PRODUCT DATA

OXYBAN 100               Chemical Oxygen Scavenger

 

 

DESCRIPTION
AND USE 

 

OXYBAN  100  is  based on catalysed sodium sulphite which reacts with oxygen to form sodium sulphate. The catalyst is incorporated to speed the reaction.

 

GENERAL
SPECIFICATION 

 

appearance ............... white powder 
non-inflammable 
non-volatile 
non-toxic

TREATMENT
AND DOSAGE
REQUIREMENTS

 

OXYBAN  100 is applied to maintain a specified concentration in the boiler water.  The  correct  treatment level depends on the boiler  pressure  and other operating conditions and will be specified by Water Guard's distributor.

Mix OXYBAN 100 with clean, cold water before use. It is very readily  soluble  and  is  not corrosive to steel mixing tanks or dosing pumps in concentrated or in diluted form.  

SAFETY

 

OXYBAN 100  is safe  to   handle   without  special  precautions  

PACKING 
INFORMATION 

 

OXYBAN 100 is available in 35 kgs.

   

IMDG class - (non hazardous)

 

 

 

 

 

HEALTH & SAFETY INFORMATION

 

OXYBAN 100 (as supplied)

 
POTENTIAL HAZARDS
 
Dust may cause  irrtation of mucous memberanes.
 
HANDLING & STORAGE
 
Avoid beating dust.
Avoid ingress of moisture.
Replace lid securely after use.
Recommended storage limit-2 years.

 

PROTECTIVE EQUIPMENT
 
Wear gloves and eye/face protection.If much dust is
raised a dust mask should be worn.
SPILL PROCEDURE
 
Sweep up spill and dispose of safety.Flush area to drain 
with plenty of water.
 
 
FIRST AID
EYES: Rinse immediately with plenty of water
for atleast10 minutes. If irritation 
presists seek medical advice.

 
SKIN: Rinse immediately with plenty of water.
INGESTION: Wash out mouth thoroughly and drink plenty of water.

OTHER INFORMATION
 
OXYBAN 100 is classified as non-hazardous.