PRODUCT DATA

SCALE BAN 2                Treatment for Boilers

 

DESCRIPTION
AND USE 

 

Scale Ban 2 is based on disodium hydrogen phosphate and is used for boilers of any pressure to precipitate calcium and magnesium hardness as a phosphate sludge.

 

GENERAL
SPECIFICATION 

 

appearance ............... off-white powder 
non-infalmmable 
non-volatile 

 

TREATMENT
AND DOSAGE
REQUIREMENTS

 

Scale  Ban  2  is  normally  maintained  within  set limits in the boiler water. The correct treatment level depends on operating conditions such as boiler pressure and on the chemical characteristics of the water employed. The optimum treatment level for any plant will be specified by Water Guard's distributor.

Scale Ban 2 should be mixed with clean water before use. Injection is normally by metering pump but alternatively a dosage pot may be satisfactory.  

SAFETY

 

Scale Ban 2 is mildly alkaline. Splashes of powder or concentrated solution should be irrigated using clean cold water.  

PACKING 
INFORMATION

 

Scale Ban 2 is available in 25 & 50 kg. bags.

 

IMDG class - (non-hazardous)

 

 
HEALTH & SAFETY INFORMATION
SCALE BAN 2(as supplied)
POTENTIAL HAZARDS
 
Dust may cause  iirtation of mucous memberanes.
 
HANDLING & STORAGE
 
Avoid ingress of moisture.
Avoid raising dust and prolonged skin contact of solution.
Do not ingest. 
Replace lid securely after use.
Recommended storage limit-2 years.

 

PROTECTIVE EQUIPMENT
 
Wear gloves and eye/face protection.If much dust is
raised a dust mask should be worn.
SPILL PROCEDURE
 
Sweep up spill and dispose of carefully. Flush area to 
drain with plenty of water.
Observe local disposal regulations.
 
 
FIRST AID
EYES: Rinse immediately with plenty of water
If irritation presists seek medical advice.

 
SKIN: Rinse immediately with water.
INGESTION: Wash out mouth thoroughly and drink plenty of water.

OTHER INFORMATION
 
SCALE BAN 2 is classified as non-hazardous.